5吨中频炉技术参数英文翻译对照

Our company designed 6000kW 12 pulse intermediate frequency power source supplied with two 5-ton intermediate frequency melting furnace，one with a preparation。The 2500KW intermediate frequency power are supplied with 2500KVA special rectifier transformer for melting。The set of intermediate frequency furnace conforms standards of GB5959.3-《Part III of the safety of electrical equipment for induction and conduction heating and induction melting equipment under special requirements》，GB10067.3-《Part III of electric equipment basic technical conditions for induction heating equipment》，and JB42- 《Intermediate frequency Coreless Induction Furnace》。

5吨/2500KW中频炉设备主要技术参数要求

序号	项目	参数	备注
1	电源进线电压	1000V ,50Hz	用户电网电压10KV
2	额定容量	5T	2500KW功率熔炼
3	额定功率	2500KW	6相12脉中频电源
4	额定中频频率	250 Hz
5	额定温度	1650℃
6	熔化率	约5T/H	中频炉连续使用
7	单位电耗	约620-650kwh/T	中频炉连续使用
8	电源冷却循环水耗量	5T/H	中频炉连续使用
8	炉体冷却循环水耗量	5T/H	中频炉连续使用
9	液压站容量	200 L
10	变压器型号	ZSS-4000 /10KV/1250	专用整流变压器（供1250KW）
11	液压介质	46号液压油
12	供水压力	0.2-0.3 MPa	到电炉端口位置
13	液压站工作压力	15 MPa	Z高18 MPa
14	进水温度	£35℃
15	出水温度	£55℃

5吨/2500KW中频熔炼炉（钢壳）成套设备标准配置表：

序号	名称	型号 , 及备注	数量	价格
一）一套5吨中频感应电炉成套供货范围及报价
1	中频电源柜	2500KW配5吨中频熔炼炉	1套
2	电容器组
3	漏炉报警装置
4	炉体（包括：油缸、铁芯、支架、感应线圈等）	5吨熔炼炉体	1套
5	坩埚模		1套
6	水冷电缆	水冷电缆侧出线	2套
7	液压站系统		1套
8	倾炉操纵台	力士乐系列元件	1套
9	设备技术图纸		1套
10	设备使用说明书		1套
11	合格证及检验报告		1套
12	中频炉维修维护保修期		1年
合计	全套设备总价格为: 万

备注：

1）用6相12脉中频电源。消除了5、7高次谐波，大大减少了电网的谐波干扰。

2）采用全封闭式冷却塔提可提高系统的冷却效果和设备的使用寿命，无须建水池。

3）06年以来我公司出口到瑞典，挪威,、拉托维亚,并大量出口到非洲,东南亚等国家.

5 ton/2500KW intermediate frequency furnace main technical parameters

NO.	Item	Index	Notes
1	Line voltage	1000V ，50Hz	Grid voltage 10KV
2	Rated capacity	5T	2500KW power of melting
3	Rated power	2500KW	6 phase 12 pulse intermediate frequency power source
4	Rated frequency	250 Hz
5	Rated temperature	1650℃
6	Melting rate	About 5T/H	Continuous use
7	Unit energy consumption	About 620-650kwh/T	Continuous use
8	Power source cooling water consumption	5T/H	Continuous use
8	Furnace cooling water consumption	5T/H	Continuous use
9	Capacity of hydraulic station	200 L
10	Transformer	ZSS-4000 /10KV/1250	Special rectifier transformer（supply 1250KW）
11	Hydraulic medium	46# Hydraulic oil
12	Water supply pressure	0.2-0.3 MPa	To electric port location
13	Working pressure of hydraulic station	15 MPa	Up to 12 MPa
14	Inlet water temperature	£35℃
15	Qotlet water temperature	£55℃

5ton/6000KW intermediate frequency furnace standard configuration table

NO.		Name	Models and notes	Number	Price
A 5-ton intermediate frequency induction furnace set scope of supply and pricing
1	Intermediate-frequency power source Cabinet		6300KW with 10 ton intermediate frequency melting furnace	1 set
2	Capacitor
3	Furnace leakage alarm
4	Furnace (includes: cylinder, core, support, Induction coil, etc)		10T Melting furnace	1 set
5	Crucible mould
6	Water cooled cables		Water cooled cable side outlet	2 set
7	Hydraulic system			1 set
8	Tilting furnace Control Panel		Rexroth series components	1 set
9	Re-designing			1 set
10	Instructions for use			1 set
11	Certificates and test reports			1 set
Total	Total price of a full set

1）6 phase 12 pulse intermediate frequency power source control system can eliminate 5, 7high-order harmonic，and significantly reduces the power grid harmonic interference。

2）Closed circuit cooling tower is used to improve the effect of the cooling system and equipment service life，without building the pool.

3) Since 2006, our company exports to Sweden, Norway, and Latvia, Africa, Southeast Asia and other countries.

http://www.minglusc.com/BdwlkjNews.asp?id=845

中频炉怎样安装调试？

感应加热炉淬火件的淬硬层深度，一般应如何选择？

感应加热炉淬火冷却装置的设计要点

感应加热炉淬火常见加热方法有哪几种？如何选用？

感应加热炉淬火件的质量检验一般包括哪些项目？